Photos
Book
Collection
Videos
Virtual Tours
Pin It Share

Edmonton Power History Foundation Blog

Category: instruments
Results: 1 to 10 of 18

Power Station Master Clock



Today, in the interests of reliability and stability, modern utilities are networked together via large scale transmission lines into a huge electrical grid made up of dozens of utilities and hundreds of generators. Edmonton is part of the Alberta Interconnected ...

read more

500kV Current Transformer

Instrument Transformer



One of the many challenges faced when operating a high voltage AC transmission network is how to monitor critical measurements in the system. Watts are important in calculating load flow and direction, accurate current readings (amps) are needed to ensure ...

read more

Kenotometer

Vacuum Gauge



  Manufactured by Brady & Martin Ltd Newcastle on Tyne This instrument is used in steam turbine condensers which are operated at pressures below atmospheric pressure.           (In a vacuum condition). ...

read more

Tags: Gauges

Commodore AL-1000 Desktop Calculator c.1968



The Commodore AL-1000 programmable calculator in the collection was originally purchased for use in the Administration building on the grounds of the Rossdale power plant. This was a very sophisticated machine for the time, although not surprisingly it ...

read more

Categories: Instruments Collection

Generator Synchronization Interactive Display



A Generator Synchronizing procedure is used to safely connect an A.C. generator to another running generator or to the grid.  Before closing the breaker several conditions have to be met on the incoming machine: The frequency must match the running ...

read more

Categories: Instruments Collection

Boiler Control Panel

1932



This Boiler Control Panel was used on the No. 2 Boiler at the Rossdale Power Plant. The panel controlled the amount of fuel and air entering the boiler furnace, which was determined by the amount of steam required at a given time. The control panel operated ...

read more

Boiler Control Console 1965

The control console was used for No. 10 Boiler in the Rossdale Central Control Room



This Console was used to control the boiler functions; such as Combustion control (Air and Fuel amounts) feedwater flow, steam pressure and the amount of steam production Manufacturer:                            ...

read more

Water Level Gauge

1932



The Water Level Gauge displays the level of water within a boiler.  The level can be seen in the centre glass on the gauge, which is also known as the gauge glass. The gauge is made from a thin strip of mica, which is less than 1/32 of an inch thick. ...

read more

Thomson Direct Current Watthour Meter

General Electric Co.



This Watthour Meter was originally used to measure direct current energy at the Canmore Coal Mine, prior to shutting down in 1979.  It was added to the EPHF Museum collection in October 2014.    Thompson Watthour Meter General Electric ...

read more

Categories: Instruments Collection

Westinghouse Phase Meter



Westinghouse Phase Meter, circa 1930, displays degree displacement between AC current & voltage inputs.

read more

Categories: Instruments Collection

Edmonton Power Historical Foundation

Location: 

We are located on the grounds of the Leduc West Antique Museum. Travel 5 km west of Leduc on Highway 39. Go north on Range Road 260 (Cohne Dale Road) for about 800 metres and the museum will be on your right. 

Hours of operation 2025

2024 is in the books, and we are looking forward to an even better 2025. The Leduc Country Lights and the Leduc Christmas Convoy were both smashing successes, and the year ended with the last day of the lights on December 31. The EPHF Museum will open again for the Leduc West Spring Swap Meet in May 2025. If, however, you are interested in a private tour, just leave a message on this website and we'll do our best to arrange a time for you to come out.
Tentative exhibition dates in 2025 are the Spring Swap Meet on May 24 & 25, the Annual Exposition on July 19 & 20, and the Fall Harvest on September 6 & 7. Plus the Lesco Truck Show in September and hopefully the Embers & Ice Pitmaster Challenge in May. Watch this space!
 

 

Leave us a message

 
 
Top